bad front end noise
#1
Junior Member
Thread Starter
Join Date: Mar 2010
Location: Vermont
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: I6
bad front end noise
I'm have some trouble with my jeep right now. When ever I turn at crawling speeds or corning with a load on the engine I get a weird grinding/rubbing noise from what I think is the front end. It just started doing this the other day and I can't figure out what is doing it. I have checked u-joints, tie rods, ball joints and bearings all are tight. I took the front driveshaft out hoping that was the problem but it was not. This is my dd so I need it to be safe. Thanks for any suggestions.
#2
CF Veteran
Join Date: Aug 2011
Location: Blue Springs, MO
Posts: 1,031
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1993
Model: Grand Cherokee
Engine: 4.0L Laredo
I'm have some trouble with my jeep right now. When ever I turn at crawling speeds or corning with a load on the engine I get a weird grinding/rubbing noise from what I think is the front end. It just started doing this the other day and I can't figure out what is doing it. I have checked u-joints, tie rods, ball joints and bearings all are tight. I took the front driveshaft out hoping that was the problem but it was not. This is my dd so I need it to be safe. Thanks for any suggestions.
#3
Junior Member
Thread Starter
Join Date: Mar 2010
Location: Vermont
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee
Engine: I6
yeah i had cut my fenders before i had bought my 32s, and then trimmed more. this noise comes even when turning slightly. also this morning i heard a pop when i pulled into a parking spot
Last edited by 1stxj; 02-17-2012 at 07:36 PM.
#5
CF Veteran
Join Date: Aug 2011
Location: Blue Springs, MO
Posts: 1,031
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1993
Model: Grand Cherokee
Engine: 4.0L Laredo
You said "checked u-joints, tie rods, ball joints and bearings all are tight".. I'd have to ask 'how' you checked them. Grabbing an axle and trying to wiggle it won't necessarily show you a bad u-joint, and there's a much better chance of them making a 'clicking, grinding' noise than a tie rod end or a ball joint. And 'tight' bearings too?
Thread
Thread Starter
Forum
Replies
Last Post
SixShooterXJCherokee
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
08-30-2015 08:06 PM
Buzball
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
08-23-2015 07:12 PM
SwankyXJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
11
08-22-2015 09:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)