Well, it's a 6 cylinder engine.... so that would be a 'no' ....

 

Did you look up what code 11 for your year vehicle means?

Was it this: DTC 11 - No reference signal during engine cranking. No camshaft reference signal was detected during engine cranking.
??

 

That would be it roller

 

So this morning I went to move it out of the garage and the battery wen dead on me. It was checked out to be good but obviously not. And the code 11 is no longer showing. Wtf? I'll keep you updated as I move along with this issue. Cheers

 

Did u already checked all the cables make dure nothing is burned ? Swapping the computer

 

I didn't see any of the wires burned or frayed. I don't have access to another computer at the moment.

 

So an update. I just replaced the battery with an optima red top and she runs a lot better. No longer has that missing sensation. I'm still replacing the cps this weekend before I drive her home. Cheers

 

Ok so I installed a mopar cps tonite and attempted to drive her home. I made it halfway through my commute and she stalled while driving. I coasted to the side of the road and she fired back up without any issue I was able to make it home with no other issues. Now I'm wondering what caused the stall in the first place....

 

All right it's been a few days and the gremlins are back. Oh well now I have a mopar cps instead of napa. I'm going to refreshen the grounds again as well as check the tps or map. Come to think of it every time my jeep goes on the fritz I check something out but I disco the battery. So the ecu resets and all is well for 20ish miles, what could be the issue? I'm about to drive this thing off a cliff lol

 

Oh and after I replaced the battery it started making a whining/whistling sound from the engine bay...what could this be?

 

I just found my fpr leaking!!!! Could this be my problem? Lol jeeps

 

Yyyyes lol

 

I got it to stop leaking but I wonder if it's bad. I haven't checked the fuel pressure yet. I just rechecked the grounds and all electrical and nothing has changed. I was able to get it to stall with no restart. Checked asd relay and no start. I unplugged the cps and plugged it back in and viola she started...so I pushed the pins back in the plug on the harness. Maybe that was it? But it just stalled every few minutes with restart...

 

So i replaced the ignition coil this morning and everything appears fixed. Won't know until the morning commute. Wish me luck

 

Alright it's been almost a week with no issues of any kind. Looks like I had a faulty ignition coil. Cheers and thanks for the help