i got my new 32s on i am trying to align the front but i cant get the tie rod to turn. with the left front wheel straight the right one definitely is not straight its pointing out. what can i do to toe it in??

 

im assuming you are loosening the 2 13mm nuts on the tierod bar and trying to turn the bar. a big monkey wrench is the way to go on that bar.

 

You may need a little propane encouragement on the threaded part to help get it broke loose.

 

make the pass tire straight and turn the tie rod to turn the drivers in you still got stock steering right

 

looks like this right

 

is the stering wheel straight do that first then lock the steerring turn the drag link to straighten the pass tire the turn the tie rod to straighten the drivers 1/8 closer in the front then the rear on the toe

 

it took a 14" monkey wrench to turn my tie rod...

 

spray the thread and pipe wrench

 

Yeah I took out my TRE's and greased them. no problem since. and my "monkey wrench" is the same as a pipe wrench lol

 

the real name is stiltsin wrench dont no if i spelled it right but they all look the same lol

 

were waiting are you done yet

 

yeah i got it to move took alot of pb blaster and an 18inch pipe wrench. going to go take it to a shop and work on it there to make sure alignment it good. didnt have to use heat but i might have to tomorrow cus i turned it as must as i could tonight. thanks for the input guys!

 

good work spray it again let i soak all night

 

just did. eventually i wanna get an ironrockoffroad tie rod bar its solid steel lol

http://www.ironrockoffroad.com/Merch...egory_Code=XST

 

get rid of the y stering all together it sucks