My key ignition keeps turning off my accessories as it won't stay forward far enough without holding it there? How could I set it up to a switch so I could just flip them myself when starting my jeep?

 

get a new tumbler?

 

Need to know what year it is to help.

 

Don't all years go back for accessories

 

Yes, but.. some switches go forward for accessory and some go back, some are adjusted at the column and some are built into the switch(DrSuess ish).
The switches up 93? can be adjusted because the are on the column and "can" fall out of adjustment. Later ones(I believe) were built into the tumbler and you have to replace the whole thing?

 

Its a 94

 

Switch on top of column either going bad or not adjusted properly.

 

Could I run the accessories off the battery to a switch in the cab?

 

Bad idea......Just replace the tumbler and or switch. For the time it takes to wire around everything you could have changed both of them twice. All total the cost will be about 35$(switch is 16ish and the tumbler is 20ish) and about 1.5-2hrs, vs the 2-5hrs rewiring your ignition.
But try readjusting the ignition switch first.

 

I go quoted close to $150 for the tumbler. And had to order it in. That was why I was wondering about the switch. Probably could find it online cheaper. Ya must adjust it underneath the plastic part of the steering column im guessing...

 

Most auto parts carry them both parts for around 20.00.

 

Not here they dont. But aside from that, I will need a steering wheel puller, and a key lock compressor to even do it on a 94. Getting pricey. So back to my original question. If anyone knows how to do that, that would be awesome.

 

ya find the accerory wire on ignition switch on coloumn under dash.Cut it add wire install relay and toggle switch should take around 2 hrs . Ignition Switch can be replace less than hour no steering wheel puller required and no cut wire harness .

 

Where you located its a standard Gm ignition switch should be readily ava...

 

ABD (always be descriptive) Man