i need a pinout for the fuse panel in my 89 Xj 4lt 5speed all the wires have rotted off the back of the fuse panel and i have no clue where they go i have a fuse panel out of my 87 camaro just need to know what wire colors are what from the back of the jeeps fuse block
Thanks

 

Sent you a PM. I replaced all the terminals in my 89 fuse block 3 years ago. The terminals had corroded bad enough that I'd have to tap the fuse block with my foot periodically to get the dash lights to come back on. Trying to clean or bend them tighter just made them break and push back inside the fuse block. It wasn't that hard to do, just awkward sitting on a milk crate outside the drivers door reaching under the dash for a few hours to crimp and solder new terminals on. Just release the old ones one at a time with a small screwdriver, replace the terminal, and snap back into the fuse block. There are a couple of 2,3,and 4 in a row that have a common terminal strip. I had a few wires that needed trimmed back enough to get to fresh copper that I ended up splicing in some wire.

See this thread for the terminal part numbers. Should be about $25 or so for a full set of terminals.
https://www.naxja.org/forum/showthre...ght=fuse+block

 

hey thanks for your help the panel was so bad just touching the thing and sparks would fly almost start the thing on fire once

 

if you could send me that pdf i would really appreciate it

 

Just got home from work and sent it.