84 lift...maybe?
Thread Starter
Junior Member
Joined: Jan 2010
Posts: 84
Likes: 0
Model: Cherokee
where can i get one of those relocaters or do you have to make one?
9)
9)
If using a coil spring compressor, take special care. Lower the axle and remove the coils.
*NOTE: Do not torque bolts to spec until vehicle lowered to the ground and set to ride height.
10)
10)
Using special care, install the new Rusty's coils.
11) Raise the front lower control arm up into position and install bolts before unloading the coils.
is it possible to change the springs with out a compression tool i thought i had seen it done with out one just reading the instructions it threw me for a loop
11) Raise the front lower control arm up into position and install bolts before unloading the coils.
is it possible to change the springs with out a compression tool i thought i had seen it done with out one just reading the instructions it threw me for a loop
CF Veteran
Joined: Feb 2009
Posts: 5,900
Likes: 10
Model: Cherokee
It is possible to change the front coil springs without the compressor tool. I did it on mine with a lot of persuasion and profanity. You can buy the relocation bracket online from several different companies like Rough Country and Skyjacker for under $30.
CF Veteran
Joined: Feb 2009
Posts: 5,900
Likes: 10
Model: Cherokee
Thread Starter
Junior Member
Joined: Jan 2010
Posts: 84
Likes: 0
Model: Cherokee
next question i have been reading and thinking that i might just go with a 2in lift from rustys with shackles and spacers would i need to relocate the trac bar and or the brake lines