im puttin my front axle back on with the new control arms and springs. i got the coils in and the lower control arms on but top of the axle needs to twist back some so that the upper arms will line up to bolt on. anybody kno how to get her to twist?

 

Yeah hook something up to the axle, like a rope and block the rear wheels in front and behind the tire, and pull on it just a little

 

ratchet straps

 

X2 that's what I had to do.

 

come along

 

i used them too, forgot to mention, they are you best bet...i attached to my bumper and axle i had two going from my axle to the bumper and one to my x member and axle

 

i tried to pull from behind and had no luck.
if i use ratchet straps where would i hook them on the axle

 

i put a pry bar in between the upper control arm and the axle and then put a jack under the handle of the pry bar and jacked up the jack that twisted the axle around no problem

 

Disconnect the lowers and install the uppers first. Makes it alot easier. Put springs in after the uppers.

 

wrap it around and put the hook back on the strap??

 

that got it.