for some reason when i put my jeep into 4x44 low or high the front axle will not engage i can feel the change in gear ratio, but its not locking in. is this 4x4 system the same set up as the tj's if so what usually goes bad. iv never had this issue with my tj.

 

I have the same problem,,,

 

Do you have a vac d30 in the front?

 

ok one thing is for sure...you guys dont have front axles with vacum...so...honestly...idk what it is..

 

no they dont...last year with that was a 1989 i believe..i could be wrong

 

yea the vacuum disconnect was on cherokees from 1984-1991 only.

 

I assume yu mean the light on the dash is not coming on. There is a vacuum disconnect on the front axle that is Detroits substitute for automatic hubs. If it is not working, it will not be in 4 wheel drive. Put it in 4 wheel drive, and jack up one front tire and see if it spins by hand. If it does, it is not working. While it is up, crawl under and try to turn the drive shaft. If it doesn't, the transfer case is working and it is the disconnect that is not. Make sure all the vacuum lines are intact. If they are, then you will have to replace the vacuum motor, a common problem.

Steve

 

belto does yours make any noises while driving in 4x4??

 

mine wont engage the 4lo but the 4hi yes, it does not make any noises but when I try to go 2x4 it wont disengage completely and that make turning hard,.. Dont know why..

 

belto what part of pr are you in? my parents are both from there dads from san juan mom from ponce. i heard there are some awesome trails out there

 

im in san juan, here in the area are no good trails but in the center of the island there are some trails im afraid to enter.. lol

 

Where did it say kermits XJ year?

 

on his intro thread. 2000 model

 

Woops.

 

dont worry about it your the admin you can edit yourself so that no one know about it.. lol