I have replacement glass, but does the black divider, between the
(rear starboard side door's) electric window and the rear 1/4 window, need to be removed, or at least manipulated forward, to put the 1/4 glass back into the door's rubber?
I removed a T10 bolt at the black divider's top connection to the door
http://superfly.co.nz/divider_top.jpg
and then a T30 bolt inside the door ~4 inches above the divider's lower end
http://superfly.co.nz/divider_bottom.jpg
and the black divider now is movable, but not easily removable.
Thanks for your advice.

 

There is a bracket under the 1/4 window that holds the glass up and in place, remove the two bolts that hold that bracket and it will come out, then the glass will slide down and you can pull it out of the frame with a little cussing.

 

Thanks, and I loosened those two bolts(also T30 head bolts), just out of view in this photograph:
http://superfly.co.nz/jeep_window.jpg
Is the black plastic divider (arrow pointing to it in the photograph linked above) removable?
Thanks again.

 

Yeah, it comes out. There is a screw on top of the door frame and a bolt down low behind the door panel, but there is also a rivit that holds it to the outer door skin that you have to break off in order to remove the divider from the door.

 

Drill bits softened the rivet, and an old screwdriver hammered down from the outside, between the divider and the door's black trim, broke the rivet.
The forward bolt holding the bracket you mentioned in your 1st post also seemed to need removing, to pull out the divider.
And the small window now is back in the door frame/rubber seals.
Thanks!