I have an Early Bronco Ford 9" that is setup for a cherokee. It will need brakes (comes with used rotors for disc brake swap but still has stock drum backing plates). It has 3.50 gears and I believe 28 spline shafts. It is old and could probably use new seals. I would also recommend new shock mounts if going in a cherokee. Open diff.

This would be an excellent swap into a cherokee if you want to keep your Dana 30. However it is 5 on 5.5 bolt pattern, you would have to run adapters on it. The width is very close to a stock cherokee. You can even upgrade the axle shafts to 35 spline and be much stronger than an 8.8. It is the axle that is bolted to the Jeep in the picture.

Asking $100. Pick up only in Linden, MI. Will trade for a full width 9".

 

3rd member right??

 

Correct.

 

hmmm..... I wish I was closer.... I want one BAD.... 8(

 

Need this gone to make room for a new axle!