Seeing if there is any interest for these axles. I'm going to one tons and would like to sell these instead of them just sitting around.

Front: dana 30HP CAD, 3.55, fork locked in, UCA above the diff cut off and a custom truss and UCA welded on for my 3-link setup, UCA changed so that the bushing is now mounted on the arm instead of the axle, LCA mounts have been drilled for 5/8" bolts, axle is from an '86 Comanche

Rear: Chrysler 8.25, 27 spline, 3.55, leaf spring perches cut off and rewelded on in the correct location, setup for SOA, shock mounts were removed as I was running the shock mounts on the spring plates, has fairly new brakes, hardware, and wheel cylinders (all were replaced and maybe have 1k miles on them), new axle hard lines (I believe both sides, would have to check, definite on the passenger side), axle is from a '93 Cherokee

I prefer to sell them as a set. If the 8.25 doesn't sell then it might get slapped under my other Comanche later on so I'm in no rush. The axles can be ready as early as this Friday (12/9).

If there is interest in parts of the Dana 30HP, I might just part that axle out once she's out from under the Jeep. If you're interested in parts off of it, feel free to PM me and I'll keep you posted on the progress.

Say like $400 obo for both axles. Axles are located under my Jeep in Wrightstown, NJ.

 

Location bro.

 

Sorry, thought I put that in there. Added it to the original post.