Where did you find these for that price? The best price I have found for them is $459.95 plus shipping, and even on the site you link to they are $423 plus.....

I agree that these look great, and have pretty much settled on them as my next mod, but if can save a hundred bucks, I would like them even more...LOL

 

Give me a call at any of the numbers below and i will get them for that price: $359.99 + $39.95 shipping in the 48 states.

 

Here is the PDF: http://bushwacker.com/Instructions/10922_r0.pdf

 

I checked out the website on your sig too.... you do not have a listing for them on there?

anyways, when I am ready to buy them, i will give you a call for sure. They are the same Bushwacker Flat Fender flares as found on Qudratec or JCWhitney? right? Or are they your own creation?

 

they're the same ones lol

 

They aren't on the because we don't really carry a whole lot fir XJ's yet (I'm working on that?) Yes they are Bushwacker's Flat Flares just like everyone else carries.

 

Sorry to resurrect this old thread, but is there any chance of getting those pictures of the 3" kit on 33s up again?

 

speaking of resurrecting an old thread.. i have the chance to get a set of these for my jeep, my fenders are already cut but nothing to extreme. i'm worried that the cut and fold i have in the rear might not work with these. how do does the rear bolt up? i looked up the instructions and they tell u to leave most of the sheet metal on the upper part of the fender which makes me assume its through bolted, something i cant do with the way they are trimmed. any input on this is appreciated and if u think it'll help i'll post a pic

 

Never say you're sorry for bringing back an old thread. If you started a new one, you'd get yelled at for not using the seach engine. It's a visuous cycle. Here is a link to a thread with a few pictures of what you are looking for.

http://www.jeepforum.com/forum/f59/x...lares-1184809/

 

Hahaha I'm one of those people that gets mad at stupid threads. Thanks for the links to pictures

 

anything thoughts on my question?

 

And you're welcome. hope they help.

 

Didn't want you to think I was ignoring you. I don't have them so I can't say if you'd be ok with them. This may be a future project for me so I'll keep an eye on this thread.

 

If you cut past where the holes are I think it may be too far just from looking at the instructions. From what I understand they are through bolted in those tops holes.

 

from looking at the instructions i figured the same thing i think i'm just going to go for them anyway and try to figure something out. i know they'll look real good on my jeep