nick_n_ii

Anyone seen this company?

Seen it on a Hot Rod show and there prices seem rather affordable..

http://tsmmfg.com/2562_44.htm (Link goes to the XJ D44)

__________________

FrankZ

I taked to a local fab shop that used to install them His experience was not 100% good. Sees that their caliper manufacture had some quality control issues and some of the castings were porus to the point that brake fluid would leach out. The defective parts never made it out of the fab shop and were replaced by the MFG....but it makes one a bit leary.

Seems like a lot of money for a set of disc brakes. I'll continue swapping in ZJ disc brakes at a fraction of the cost of the TSM kits.

__________________
9/11 - WE WILL NEVER FORGET!! (<---<< click)

bigbadxj

Yea ZJ Brake backing plates take very little fabing to work and can be found easy and cheap. I am going to have a couple sets for sale soon.

__________________
"The very existence of flame-throwers proves that some time, somewhere, someone said to themselves, You know, I want to set those people over there on fire, but I'm just not close enough to get the job done." George Carlin
WWW.XJTALK.COM

nick_n_ii

Ya I know all about the ZJ parts ( I have a set that I'll be installing come spring)

Just thought it was a cool bolt in idea for those less fab savy...

I did see on the site where you can choose just to get the mount and tells you what vehicle to source your calipers and rotors from..

__________________