No worries, I added a blue line to the picture that relocates the pivot point of track bar.

 

it may look close to correct in that photo, but unless you dropped the frame side mount also, you should not relocate the axle side down. Don't use that piece of the kit or you'll end up with bump steer.

Not to mention you're putting the frame side trackbar TRE joint at a more extreme angle then it needs to be - you'll only limit your suspension travel and cause the joint to wear out faster.

edit: SteveMongr got it correct in the edited photo

 

SteveMongr and Dukie564, Great, thanks for the explanation. Makes sense now. Guess I'm a visual kinda guy lol. I was focusing on the bars themselves rather than pivot point to mounting point. I see why dropping the axle end threw them out of alignment. I also see why adding a drop pitman arm would only exaggerate the issue.

Thanks a ton for the advice/explanation.

 

Just to update this thread. Got the sway bar end links mounted up. And the bar alignment should be good to go!

Thanks again guys.