I can't wait to test it out lol

 

Installed Putco headlight harness, hella h4 headlight conversion, and sylvania silverstar ultra bulbs! Such an amazing difference!!!!

 

And finally this last weekend, my hellas 700ff went on to my bumper. I had to raise them a little bit with a spacer and find a longer bolt, but other that that I like the end result!

https://www.dropbox.com/s/13dg3lagfa...8ffa824e72.jpg
https://www.dropbox.com/s/udt8uccxohj2qxp/image.jpeg

What do you think??

 

Campus popo pulled me over, apparently there was a curb under a snow pile I climbed. Luckily he let me go, had me shaking for a minute.

 

Towed the other white beast home with it :P

 

stretching it out before the shacle relocators

not my best looking welds but they shall hold

the new shackle and shackle relocator going to build a brace for it when I time. had to buy longer shackles cause I was off in my design and my MJ shackle flated out when I used them.

stretching after the new stuff



so over all reaction jeep sits .5" higher than before, going over bumps is alot and I repeat alot smoother. she flexes better with little to no. issue. next is zj coils and 1500 ram front shocks. thanks Demonoid369 for helping out.

 

Stretching? Do explain please.

 

Flexing out

 

I like the square look on the fenders.
I did something similar.
Check out my thread.
https://www.cherokeeforum.com/f46/pbr-inspired-xj-189166/

 

Fixed the broken door plug wires.
Added insulation and looming to clean it up.
Celebrated with a few cold ones.

 

should be getting my winch mount built soon (fingers crossed) so i started the wiring for it. moved a thing or two around and got the solenoid box mounted with the rest of my electronics under the hood. you can also see the accessory fuse block i added in front of the relocated original one. tomorrow i extend the remote plug once i decide where to put it. part of me wants it inside the cab, but i'm also thinking of mounting it in the bumper skin or maybe the corner of the fender. bah.. decisions

 

been fallowing your build like alot of your ideas

 

sorry I didnt say flexing but thats what ment.

 

I put a Dash Cam in my jeep today. If you are board take a five min drive with me from downtown Juneau to my house. the audio picked up the radio so there is something to listen not just a quit drive.lol that rattle is the cb mic hitting the cam I fixed that.

 

Installed some rear quarter armor I picked up on the cheep