Jeep Cherokee Forum
0 2016/06/20 12:33:30
0 2016/06/16 20:43:07
0 2016/06/15 19:34:35
0 2016/06/15 19:33:13
Had to grind a little off the swaybar bracket for clearance.
Had to grind a little off the swaybar bracket for clearance.
0 2016/03/18 04:42:29
Swapped original zerk for 90° zerk but it was bigger
Swapped original zerk for 90° zerk but it was bigger
0 2016/03/18 04:41:41
New & old trackbars
New & old trackbars
0 2016/03/18 04:41:15
0 2016/03/15 15:58:01
0 2016/03/15 15:57:56
0 2016/03/15 13:49:13
0 2016/03/15 13:45:09
0 2016/03/15 13:44:41
0 2016/02/29 13:37:33
0 2016/02/29 13:37:24
0 2016/02/29 13:37:13
0 2016/02/29 13:36:53
0 2016/02/29 13:25:25
0 2016/02/29 13:24:52
0 2016/02/28 23:41:33
Badwater Basin
Badwater Basin
0 2016/02/28 23:36:42
0 2016/02/28 23:35:43
0 2016/02/27 17:02:41
0 2016/02/27 17:02:15
0 2016/02/27 16:59:46
Factory with worn 31" tires & 1.5" blocks & extended shackles in, the rest will have to wait.
Factory with worn 31" tires & 1.5" blocks & extended shackles in, the rest will have to wait.
0 2016/02/27 16:59:20
0 2016/02/26 18:47:30
0 2016/02/26 18:24:13
Took a new pic of my ride yesterday
Took a new pic of my ride yesterday
0 2015/12/06 10:44:39
0 2015/11/07 15:58:36
0 2015/11/07 15:58:19
Yikes, $7500? For a 2wd??
Yikes, $7500? For a 2wd??
0 2015/10/16 08:31:25
And so this is the kit I used. I think it cost about $4 from Harbor Freight. The rods about about 12" and pretty flexible... the small transparent rod is an end-piece and super flexible but I only used the hook end.
And so this is the kit I used. I think it cost about $4 from Harbor Freight. The rods about about 12" and pretty flexible... the small transparent rod is an end-piece and super flexible but I only used the hook end.
0 2015/09/27 23:45:01
And then up to the dashboard where you can route it wherever you want to and you can just push it under the edges of the trim where needed so it's completely concealed and clean.
And then up to the dashboard where you can route it wherever you want to and you can just push it under the edges of the trim where needed so it's completely concealed and clean.
0 2015/09/27 23:42:46
It took me about 45 minutes to fish through because I was being careful and hadn't done it before but could probably be done in under 30 minutes easy.
It took me about 45 minutes to fish through because I was being careful and hadn't done it before but could probably be done in under 30 minutes easy.
0 2015/09/27 23:41:01
And since it comes in 1' sections you just add and remove as necessary. This is up in the driver floorboard with the two front screws removed instead of having to remove all the trim along the driver side.
And since it comes in 1' sections you just add and remove as necessary. This is up in the driver floorboard with the two front screws removed instead of having to remove all the trim along the driver side.
0 2015/09/27 23:39:00
Which is what happened to me so I added a little rubber band insurance.
Which is what happened to me so I added a little rubber band insurance.
0 2015/09/27 23:37:39
But don't try to pull the wire through with it sliding through the hook because it's hard on the wire and it will get stuck.... give it enough slack to make it all the way to the destination and it's pretty easy. But if you back the hook up the wire will probably come off and you can't get it hooked again.
But don't try to pull the wire through with it sliding through the hook because it's hard on the wire and it will get stuck.... give it enough slack to make it all the way to the destination and it's pretty easy. But if you back the hook up the wire will probably come off and you can't get it hooked again.
0 2015/09/27 23:34:48
0 2015/09/27 23:33:48
0 2015/09/27 23:32:48
0 2015/09/27 23:31:35