Jeep Cherokee Forum
0 2015/04/30 11:34:24
Here's the rig, (that's not my oil thank god)
Here's the rig, (that's not my oil thank god)
0 2015/04/30 11:35:45
0 2015/04/30 11:37:45
My pinion angle as it sits right now after I adjusted my uppers
My pinion angle as it sits right now after I adjusted my uppers
0 2015/06/04 16:38:24
0 2015/06/04 16:39:22
Here's the bend in the spring, not sure if that's acceptable or if it could go some more to achieve proper pinion angle
Here's the bend in the spring, not sure if that's acceptable or if it could go some more to achieve proper pinion angle
0 2015/06/04 16:40:20
Here's the ball joint at the pitnan arm side. I know an over the knuckle system would be best but for now this is in my budget.
Here's the ball joint at the pitnan arm side. I know an over the knuckle system would be best but for now this is in my budget.
0 2015/07/25 14:32:39
This is after I installed the steering conversion and got the front aligned. I have always had the trac bar in also just hard to see in the other pics
This is after I installed the steering conversion and got the front aligned. I have always had the trac bar in also just hard to see in the other pics
0 2015/07/25 14:46:20
0 2015/08/06 15:16:35
Passenger side rubs spring. Not sure if it's because it's from a zj
Passenger side rubs spring. Not sure if it's because it's from a zj
0 2015/08/06 15:17:33
Had a 4x4 shop do the front alignment, sacrificed some pinion angle but drives good. Track bar and caster seem to be in alignment.
Had a 4x4 shop do the front alignment, sacrificed some pinion angle but drives good. Track bar and caster seem to be in alignment.
0 2015/08/06 17:50:37
I am running ruggid ridge crossover system but have almost no dead spot.
I am running ruggid ridge crossover system but have almost no dead spot.
0 2015/08/06 17:50:45
0 2015/08/09 11:25:18
0 2015/08/17 20:26:59
Deciding to weld to old mount or grind off the old mount entirely. In that case I would have an experienced shop do the fab work. But as I have set everything up it seems like the discos will be at a much better angle if the new brackets take the place of the old ones as opposed to welding it on top of the stock bracket and leaving an offset.
Deciding to weld to old mount or grind off the old mount entirely. In that case I would have an experienced shop do the fab work. But as I have set everything up it seems like the discos will be at a much better angle if the new brackets take the place of the old ones as opposed to welding it on top of the stock bracket and leaving an offset.
0 2015/08/17 20:27:41