stalling when coming to a stop... still
been havin this problem for years now. if i adust tps it goes away for a day or two then acts up again. tried re doing the splice in the ground wire, cleaning the c101 new tps and iac. added battery ground. i tried to run a direct ground spliced into the tps ground wire but it just makes the idle race like at2000rpm, wont go down no matter what, i read that guys have done it with success so i dont know whats up with it. runs good other than that tho. does it worse with ac on.
88 5speed 90s motor, all sensors reading correct through snap on scanner. |
Are you adjusting the TPS correctly? Engine side per the instructions at www.cruiser54.com?
|
Yes. wierd it will run fine for a few trips after adjusting then go back to acting up. I thought tps was bad, but no. its not the throttle body either, i just installed a bored one from the guy on your site. engine does blow by alot but since it runs good after adjusting i think its something electrical. Do you have any idea why running a new ground for the tps would make it freak out? couse i dont understand it. unless the ecm supplies ground.
|
Originally Posted by Gmaster
(Post 3313632)
Yes. wierd it will run fine for a few trips after adjusting then go back to acting up. I thought tps was bad, but no. its not the throttle body either, i just installed a bored one from the guy on your site. engine does blow by alot but since it runs good after adjusting i think its something electrical. Do you have any idea why running a new ground for the tps would make it freak out? couse i dont understand it. unless the ecm supplies ground.
The moment the tps gets any type of liquid that hits it, it'll be a crap shoot after a couple days.... Also, have you deleted connecter c101? |
Originally Posted by 88whitecomanche
(Post 3313670)
Try unplugging the tps and drive it, I had similar issues and I ran with out a tps for a week until I bought one and adjusted it to cruisers tips...
The moment the tps gets any type of liquid that hits it, it'll be a crap shoot after a couple days.... Also, have you deleted connecter c101? |
Originally Posted by Gmaster
(Post 3313672)
no i havnt deleted it, i guess ive been putting that off for a while. but i did clean it. I would think that it would run like total crap with the tps umplugged. i ruled it out by replacing it.
|
All times are GMT -5. The time now is 10:02 PM. |
© 2024 MH Sub I, LLC dba Internet Brands