semi new.
 

hey guys, ive been lurking the last couple days because im about to buy me a cherokee. from what i have seen/heard they are very solid.

i found a pretty good deal on a 99 with 150k a couple hours from me and im going to pic it up in a couple days. anything i should be searching for? is rust a huge issue? i hear the motors have minor lifter tap but other wise the motor is near bullet proof. and it being a 99 most of the quirks would most likely have been taken car of in the earlier years.

so any advice when trying to make sure im getting a solid truck?

thanks guys. hope to be around for a long time.
btw im located just outside of stl mo. in a town called bethalto il.
i have a lot of offroad experience but looking to get into jeeps now. i have a motor swapped nissan frontier running mid travel 35s yadada. its been getting worked on for a while now and i need a dd in the mean time.

Andrew.

TEST DRIVE IT!!!! make sure 4wd works

welcome to the site. I'd check everything out first.

thanks for the heads up guys. ill be test driving it for sure. and im going to rape it with my eyes and hands top to bottom. i just didnt know if there was anything in particular.

hmm, i found another one for very very cheap.

the only bad part is it has 240,000???? how long is the general use on these motors?

Sup man? See your joining the dark side.






get your damn frontier running already

lol hey man. hate you.
im working on it, its all down to wiring right now though.

Welcome to CF.

the 4.0 will almost forever a friend of mines went 638,000 1 cracked exaust manifold thats it mines at 257,00 still goin strong!

all good man nice to see another familiar name on here, think Nism05 is on here 2

heard that, you were honestly one of the reasons i got an xj. so thanks:)
very nice. i wish i lived closer to ya so you can help me out with the jeep i just bought!

its a 93 with 300k paint is gorgeous and very little rust. well taken care of by an older guy. ill grab some pics later. im taking it in for an alignment today and hopefully getting a new windshield tomorrow.

sooo clean for a 93. going to remove the pin stripes and the little graphic. fixing a few little rust spots and coating the bottom in black. needs tires. i dont like how easy the wheel is to move. so steering stabilizer should remedy that soon.
i also dont have a center console. anyone know where i can grab a gray one?
other than me being picky. very nice find if i do say so myself.
[URL=http://img835.imageshack.us/i/001pla.jpg/]http://img835.imageshack.us/img835/8775/001pla.jpg
[URL=http://img20.imageshack.us/i/002dyy.jpg/]http://img20.imageshack.us/img20/592/002dyy.jpg
[URL=http://img408.imageshack.us/i/003dguc.jpg/]http://img408.imageshack.us/img408/2827/003dguc.jpg
[URL=http://img819.imageshack.us/i/004quh.jpg/]http://img819.imageshack.us/img819/1968/004quh.jpg

lol man, nice start throw a set of long arms on that ish and have fun

lol i cant do that just yet.
close future plans. 3in, soft8s, retreads.

wooooooohhhhh. got a lot done on the jeepyjap today.


swapped out gauge cluster from idiot lights to an actual one. got oil pres, broke the water temp one while taking it off so ill have to tap another one........ arg.....
got a center console. a new center face place. a new passenger mirror. didnt take any pics of install unfortunately. but will post pics in a couple minutes. i got a vent that im kinda missing too, then i lost it. damn... other than that it was a spectacular day.

opp couple things pissed me off. the head unit was held in with wooden shims with elc tape around them..... and the hvac unit was held together by the head unit.
so now i need a new switch plate on the hvac unit because the mounts are broke. and the head unit is just kinda hanging there until i can get a bracket in there.

more soon.