Mark this thread as Unsold
FS[NorAtl]: 98 4dr xj parts
#1
CF Veteran
Thread Starter
98 4dr xj parts
Okay not all parts available. Jeep was totaled and I'm keeping some.
I have an almost full set of interior panels. Dash top charcoal, dash lower tan and everything else is tan. Liftgate panel cracked in half on one side at the top left but usable. Piece across floor at liftgate opening is junk. Drivers seat side panel broken and passenger airbag deployed so that cover is no good. Everything else good though. I'll throw in the center consol too. Not perfect but not bad. Does not include door panels.
-4 doors. Chili pepper red. All power. Charcoal/tan panels. Both rears have dents. Both left side have a little rot. Scratched but literally will probably buff out ok. Right rear is missing the small stationary window. Both right side doors are virtually rust free. Will be fully assembled including mirrors, ready to bolt on and plug in. Fully functioning, but driver window regulator makes a skipping sound when widow closes. $80 for the set. $25 each if separated.
-Tan passenger seat ok but quite dirty. $10
-Rear seat bottom. Quite dirty as well and cover looks a little loose. $10
-Right fender. Was tweaked a little but probably usable. $10
-Carpet ok but filthy. Foot areas worn through to backing. $free
-Both tail light harnesses $10
-overflow bottle $10
-gas tank $20
-center console $20
-headliner and everything that mounts to the roof. 2 lights, visors and speaker mount with grills $50
-all the interior panels $50
Not sure wether I will pull the motor but may just strip it and leave just the block with crank and balancer in. Has 227k on odometer. Not sure of any details but it was a kids daily driver until he totaled it.
Not sure if I'll ship anything. Would be willing to meet. Address is Connecticut 06018. Kinda in the middle of nowhere. Could meet near Albany NY. near Hartford CT. Not sure how far toward Springfield MA I would go. Also toward Poughkeepsie NY. Pittsfield MA. New Milford CT. This is about a 50 mile radius from me. Except Springfield which is a little farther.
I have an almost full set of interior panels. Dash top charcoal, dash lower tan and everything else is tan. Liftgate panel cracked in half on one side at the top left but usable. Piece across floor at liftgate opening is junk. Drivers seat side panel broken and passenger airbag deployed so that cover is no good. Everything else good though. I'll throw in the center consol too. Not perfect but not bad. Does not include door panels.
-4 doors. Chili pepper red. All power. Charcoal/tan panels. Both rears have dents. Both left side have a little rot. Scratched but literally will probably buff out ok. Right rear is missing the small stationary window. Both right side doors are virtually rust free. Will be fully assembled including mirrors, ready to bolt on and plug in. Fully functioning, but driver window regulator makes a skipping sound when widow closes. $80 for the set. $25 each if separated.
-Tan passenger seat ok but quite dirty. $10
-Rear seat bottom. Quite dirty as well and cover looks a little loose. $10
-Right fender. Was tweaked a little but probably usable. $10
-Carpet ok but filthy. Foot areas worn through to backing. $free
-Both tail light harnesses $10
-overflow bottle $10
-gas tank $20
-center console $20
-headliner and everything that mounts to the roof. 2 lights, visors and speaker mount with grills $50
-all the interior panels $50
Not sure wether I will pull the motor but may just strip it and leave just the block with crank and balancer in. Has 227k on odometer. Not sure of any details but it was a kids daily driver until he totaled it.
Not sure if I'll ship anything. Would be willing to meet. Address is Connecticut 06018. Kinda in the middle of nowhere. Could meet near Albany NY. near Hartford CT. Not sure how far toward Springfield MA I would go. Also toward Poughkeepsie NY. Pittsfield MA. New Milford CT. This is about a 50 mile radius from me. Except Springfield which is a little farther.
Last edited by Waynerd; 09-04-2016 at 11:06 PM. Reason: Changing prices and deleting some statements
#5
CF Veteran
Thread Starter
Corner of driver door got bent pulling it on the trailer. I yelled for the guy running the winch to stop but he didn't and it caught on a car next to it. Luckily I was able to pull the door closed or it would have messed it all up.