tom woods custom drivshafts
Thread Starter
Newbie
Joined: Oct 2012
Posts: 27
Likes: 0
From: Virginia
Year: 1999
Model: Cherokee
Engine: i6 4.0
tom woods custom drivshafts
upgrading to 6.5 rusty's longarms. what are you guys with that setups length of your tom woods custom driveshaft? and with that length will I run into any problems using it on my 4.5 short arms until I get my new kit? thank you
CF Veteran
Joined: Oct 2011
Posts: 4,440
Likes: 3
From: Seal Beach, CA
Year: 1996
Model: Cherokee
Engine: 4.0 HO Straight Six
Every XJ is different. Your best bet is to wait on the SYE until you lift it. Once you lift it, then measure.
If you're dead set on doing an SYE beforehand, I'd say do the SYE with a JY front shaft for now. Once you go to 6.5" then measure and get a DS from Tom Woods
If you're dead set on doing an SYE beforehand, I'd say do the SYE with a JY front shaft for now. Once you go to 6.5" then measure and get a DS from Tom Woods
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)