codysmith123456

how do i remove my aftermarket bumbstops in order to slide the extra spacer for the coil off. there are currently 2 spacers but for my new coils i only want one.

96_xj

spacer?? pictures may help there are alot of different types and variations

codysmith123456

hard to see, but you get the general idea. i need to remove the bumpstop in order to slide one of those spacers off.

wiggles

Just pull on it and it will pop out

OOdynamite

X2

wiggles

Unless the po decided to glue it in

codysmith123456

the two spacers themselfs are loose, and can move seperatly up and down about 6 inches. towards the bottom of the bump stop is a flared edge and the spacers wont fit past there. i cant tell if the bump stop is threaded on there or what...

wiggles

No the bump stop just pushes in. Are the spacers urithane? Like flexible, then just take a hammer and knock it over the lip

wiggles

Wait are you talking about the rubber bump stop or the tube that the bump stop goes into?

codysmith123456

im talking about the piece the bumb stop goes onto..
in this picture its the black peice.. i got one to spin but it doesnt seem threaded

wiggles

The tube doesn't come out

codysmith123456

so both spacers are stuck??????????

wiggles

No they should come off of the bottom

codysmith123456

they will not slide over the black cylinder(1 up from the bump stop)... between the bumpstop and shiny aluminum cylinder

codysmith123456

anyone?