Hey, so after rollin my xj last week im rebuilding it and pulling a full cage out.of.dom tubing. I don't know where to mount or start it from? Do i just weld the tubes to the floor board? or cut holes in.the floor and order frame stiffeners and somehow bend the tubes down to those? Or.how do i go about this? and.help or guidance would.be greatly appreciated!!!

Ps, when i do this again...




I don't want.to have to worry about the whole top comin in, so any help is greatly greatly appreciated!!

 

You're gonna want to tie it into the unibody as much as you can. There's a couple good threads in the fab section you can check out