Rock sliders
I have JCR stage 3 rock sliders but no hardware bought them used so will it work if i weld 1/8 plate to the mounting points on the rock sliders then weld it to the unibody with the 1/8 plate welded to the sliders or any ideas im open to hear
|
I just welded them on. Jcr stage 3, if you are welding a plate to it and then welding to the "frame" I would go with 3 16/ths, as that's what my slider came with.
http://i494.photobucket.com/albums/r...-31-55_944.jpg http://i494.photobucket.com/albums/r...0-32-04_78.jpg |
Do you have frame stiffners?
|
You could just look up the hardware kit on their website if you dont feel like welding.thats what I did when we built my sliders,I just copied their(JCR) hardware list.
|
I was going to order but i get bored and like to weld with my new welder but is it easy to wd unibody to 3/16 or whatever the sliders are
|
yes I do have stiffeners.
|
I plan on weldinf it straight to the unibody ive welded 1/4 plates to the front of the my unibody before im just going to bevel the edges of the playes where they meet the unibody and burn em in there
|
3 Attachment(s)
Burn them right into the stiffeners.
|
Originally Posted by Gorillaxj
(Post 1354656)
I just welded them on. Jcr stage 3, if you are welding a plate to it and then welding to the "frame" I would go with 3 16/ths, as that's what my slider came with.
http://i494.photobucket.com/albums/r...-31-55_944.jpg http://i494.photobucket.com/albums/r...0-32-04_78.jpg Just make sure your welds don't look like this! |
I also made a bracket that attaches the ends to the floor board via 3/16" plates and bolted under the carpet. You can see it on the bottom pic left and above of the leaf spring.
I'll snap some better pics in the morn. |
Originally Posted by Gorillaxj
(Post 1354656)
I just welded them on. Jcr stage 3, if you are welding a plate to it and then welding to the "frame" I would go with 3 16/ths, as that's what my slider came with.
http://i494.photobucket.com/albums/r...-31-55_944.jpg http://i494.photobucket.com/albums/r...0-32-04_78.jpg |
Looks like they are on the cross member like a RC Y link set up.
|
I have RC long arms and the jcr sliders i called and asked them they said they make them so you can mout aby point along the unibody
|
All times are GMT -5. The time now is 04:43 PM. |
© 2024 MH Sub I, LLC dba Internet Brands