MUKAK

i had 2 inch blocks and add a leaf and everything was fine and even.. i just installed 3 inch Pro Comp full leaf packs and now my rear end is uneven ( driver side is 1 inch lower than passenger ) WTF?

i didnt tighten the shackle bolts till after i let it settle ( drove around for 2-3 miles )

any ideas?

JJCIII

Did you make sure that one isnt backwards? And im assuming you have the correct amount of blocks and or leaves...

MUKAK

The spring came complete from 4wheelparts.com. How can I install them backwards?

JJCIII

Obviously i havent seen your springs but i have seen some that are hard to tell which end goes to the front and which sits in the rear. You have a strange issue. Do you have any pictures?

Big David

Put a lift shackle on the lower side & stock shackle on the high side.

FIXED.

MUKAK

yes i have a few blocks i can add to compensate.. but i still wonder why it sits that way? do u think i might have a defective springs?

Keaton

You sure it hasnt always been like that? Both XJs ive owned and almost every jeep i see is a little lower on the passenger side.

Power73

That would be the half *** way to fix it. The springs shouldn't be that much different. I'd call/email 4 wheel parts and see what they say

Big David

He said "any ideas",I gave him one.Yes,it's 1/2 azzed & was intended to be a smartazz coment as well, but it IS a option.

My first option would be send them back or contact the company he got them from & let them fix the issue.

OP,ditch the blocks.It induces axel wrap/early spring fatigue.

MUKAK

mine is a little lower on the DRIVER side after spring install....

MUKAK

no blocks added in the back.. i took the blocks off and installed the 3 inch leaf packs from PROCOMP actually thinking about going back to blocks haha

Power73

why? just get a hold of 4wheelparts and let them know whats going on

MikeT2

Did you set them side by side and check to see if they were the same before you installed them? The reason that I ask is, that I ordered 3" lift spring packs and when they were delivered and I set them side by side they were not the same. Come to find out after checking them out they sent me spring packs that were built up from 2 different companys and they did not have the same spring rate even though they had the same P/N on them.

XJ-92

x2.

MikeT2

The spring bolt that holds the spring leafs together is not on center of the spring, so if he would have installed one backwards the axle would be at one hell of and angle and very noticeable.