AutomaticKrackr

Ive heard that rubicon under rates their lifts.From my experience it tru.My question is....With the 3.5 super flex what is the actual lift height?My problem is I only have my lift to compare.

gvns8

When I had 3.5" RE coil springs in the front and I measured it using the "dirty" method (from top of axle to frame seam, it was 3.75" in the front. Those springs were old though and probably settled. I would guess they started maybe at 4".

gvns8

Also my rear now has 3.5" spring packs from RE and a shackle. The total height is 5.5" in the rear right now, and I am not sure if the shackle is 1.5" or 2" longer than stock. This means that the pack is either exactly 3.5" or it is about 4".

Hope that helps. In my case it seems like the trend is about a maximum of 1/2 inch higher than stated.

Many people also forget to account for the fact that their current springs have sagged because they are worn out-in which case you will see a greater increase in lift height.

jmm0122

Im running the 3.5" super flex and mine sits at 5" rear 4.5" front.

Pat Vogt

Way under rated. My buddy had a wrangler that he put a RE 4.5 on. The thing measured in at almost 7 when it was done...

okcjeeper

Well I measured mine from start to finish and after a year I am sitting at 4.25 front and 4.75 rear.

steelersfreak84

after running mine for three years now, my front is right at 3.5 and the rear is around 4

AutomaticKrackr

Cool!Thanks guys.The reason i was asking,Im looking at the Ironrock long arm kit. It states that you must have at least 4" of lift.That makes it a bit easier thanks!!

Jeepguy333

I put the re5.5" springs in the rear of my 93. It's sittin just over 6.5

Metmknice

You should also check out FrankZ 's Longarms.