rawk krawler

Hey guys I bought an AA sye a couple months ago for around $250 and it irks me that I haven't installed it yet. I am putting it in a 95, which has the older style caged needle bearings that have to be removed and put onto the new shaft. Do I need a bearing press to remove OR install the bearing? Thanks in advance

Atmos

I just did this to a friends last night. used a socket and hammer. easy peasy

rawk krawler

Damn that's awesome news and disappointing as well, called in and they swore up and down I needed a press haha!

Thank you very much I'm going to install it tonight!

rawk krawler

How long would you say this project takes? And do I need an impact gun?

Atmos

actual install takes an hour tops. uninstalling the case and reinstalling was a pain. I used an impact for the nut that goes on the yoke. good flat head snap ring pliers will be the most impotant tool.

rawk krawler

Could I get the nut off with a breaker bar, or will it just spin?

paperxj

Just put the TC in 4 low and put a pry bar in the front yoke. It helps if you have some one to help you.

rawk krawler

Sweet thanks guys

rawk krawler

How tight do the yokes need to be tightened down

sneakyjap96

I got the job down in less then 30 mins never pulled the tcase and an impact is the way to go an to tighten it if u have an impact just run it down tell its tight the torque spec is like 190 ftlb i think

rawk krawler

I have an ax-15, will a front driveshaft from an 89 with an aw4 work for this project?

rawk krawler

4.5 front 5 rear