Lift blocks
Thread Starter
Junior Member
Joined: Aug 2011
Posts: 42
Likes: 0
From: Indiana
Year: 2001
Model: Cherokee
Engine: 4.0
So I need some cheap unsaggy leaf springs. You guys know where I can get some. Or if I get leafs from a Cherokee from a salvage yard do you think they will be as saggy
Trending Topics
Newbie
Joined: Sep 2011
Posts: 20
Likes: 0
From: Massachusetts
Year: 2001
Model: Cherokee
Engine: 4.0 I6
everyone on this forum hates on aal and blocks hahahaha. I have a 3 in aal and 1 inch block and it works out great for me and ive been running it for a good 3 months.
Senior Member
Joined: Aug 2010
Posts: 1,012
Likes: 1
From: NC/SC
Year: 1990
Model: Cherokee
Engine: 4.0
My block in the back had a stress crack in it when I finally decided to put new leaf packs on it. It could have gotten bad ifi didn't replace it. It will also make your axle wrap horrible and rattle a lot. I'd just save up and get new leaf packs or shackles.
CF Veteran
Joined: Mar 2009
Posts: 2,750
Likes: 3
From: Visalia, Kalifornia, ussa
Year: 1996
Model: Cherokee
Engine: 4.0
Go to a junk yard get son rear leafs from either a S-10 or Dakota. The do research on building a bastard pack. Used leafs will be pre sagged, so that worry is gone. With the B-pack you will be able to do from 1" to 4" of lift depending on the leaf combination used.
Seasoned Member
Joined: Jun 2011
Posts: 386
Likes: 0
From: in a small town named ...
Year: 1997
Model: Cherokee
Engine: 4.0L
If u really want block or shackles I'd go to rockyroadoutfitters.com they have solid steel blocks not the hollow aluminum (or whatevermit is) ones every one else sells. I got both shackle and block set up on my rear and my leaf springs are completely flat. But if I could do it again I woulda saved up for full coil springs (hot 3" pucks there too) and full leaf packs.
CF Veteran
Joined: Mar 2010
Posts: 47,923
Likes: 38
From: Broward County Fl.
Year: 1989 xj sport 2dr
Model: Cherokee
Engine: 12 hole bosch Injectors
ive run blocks on all my 4x4 vechicles, a week spring and blocks is not a good idea leaf springs must be in good shape ive never had a spring or block failure. you must retighten u bolts after install
Last edited by freegdr; Dec 30, 2011 at 12:41 PM.



