LCA Length for CADs
#1
CF Veteran
Thread Starter
Join Date: Jun 2011
Location: Colorado
Posts: 2,448
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0
LCA Length for CADs
I have the RC CADs and just picked up some adjustable LCAs for them. When screwed all the way down, they're 16''. Is that too long for the CADs on a 6.5'' lift?
Here's a pic:
Here's a pic:
#2
Junior Member
Last edited by Lowrange2; 12-11-2012 at 12:37 PM.
#3
CF Veteran
Thread Starter
Join Date: Jun 2011
Location: Colorado
Posts: 2,448
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0
Oh awesome. So all I'll have to do is extend them a little bit depending on the length I need for my lift.
Thanks
Thanks
#4
Senior Member
Join Date: Jun 2010
Location: riverside,ca
Posts: 566
Likes: 0
Received 1 Like
on
1 Post
Year: 2001
Model: Cherokee
Engine: 4.0L
That yucca man thread didn't work for me, measurement wise, I think they are all different depending on setup and all that. I've screwed around with my arm length with my cad brackets millions of times and still haven't got it right....good luck buddy.
#5
Junior Member
Well, that chart is a starting point.
Just set them there, install the axle then adjust to get the correct alignment numbers.
Just set them there, install the axle then adjust to get the correct alignment numbers.
#6
CF Veteran
Thread Starter
Join Date: Jun 2011
Location: Colorado
Posts: 2,448
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0
Oh ok. As long as my arms will fit and aren't too long, I'll figure it out. You like the CADs? Night and day difference I take it?
#7
CF Veteran
Thread Starter
Join Date: Jun 2011
Location: Colorado
Posts: 2,448
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1992
Model: Cherokee
Engine: 4.0
Apparently the RC and RE CADs are different, according to that chart. Am I going to run into an issue then with my 16'' LCA and the RC brackets?
I didn't put much thought into it, but I'm running a 1.5'' spacer on top of my 6.5'' coils.. I don't know why I didn't remember that. That Yucca chart shows 16'' for RE at 7'', but nothing for RC. I'm assuming it'd be OK.
I didn't put much thought into it, but I'm running a 1.5'' spacer on top of my 6.5'' coils.. I don't know why I didn't remember that. That Yucca chart shows 16'' for RE at 7'', but nothing for RC. I'm assuming it'd be OK.
Last edited by 92XJGuy; 12-11-2012 at 09:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)