MSJeeps911

Hey guys my gf and I did some work on her jeep. She installed the trac bar and its pushed to the ds too much. We decide to drive it. Whats werid is it pulls to the right. Shouldnt it pull too the left?. Ill fix it in the am but im just curisous if the trac has to do with pull. As its pulling the opposite way

94XjSport94

Is it adjustable? stock hole in the axle?

MSJeeps911

Yea I can adj it lol. Just asking cause its off to drivers side why is jeep pulling to the pass side when driving. Alignment is fine toe is good
. I had it on my zj off to left pulled to left this is backwards on the cherokee.

94XjSport94

Make sure its the right length first. If its too long or short i would imagine it would in fact pull to one side. Use a level and measuring tape to make sure its centered right in the wheel well on both sides.

MSJeeps911

Will do. Just never seen it off too one side pull to other kinda weird too me. Ill play with it in am.and then get back.


If anyone else has a thought please let me know asap

yarom

Had the same issue. Had to align three times.

Solved it two ways - readjust the rear axle a tiny bit. There is a bit of play once you loosen the U bolts and you want it to be perfect.

Switch lower ball joints to adjustable and that brought it together and got rid of almost all the right pull I had.

Stock adjustment is very limited and might not be sufficient after a lift...

MSJeeps911

Thanks. The rear is set fine. Maybe off 1/4in. Fronts off like 1in. Ill push it towards the side it pulls too.