Flux wire welder strong enough? lca mount
Thread Starter
Newbie
Joined: Aug 2011
Posts: 15
Likes: 0
From: Breckenridge, Colorado
Year: 94
Model: Cherokee
Engine: 4.0L
Flux wire welder strong enough? lca mount
I need to replace my LCA mount and only have access to a hobart handler 140 with (flux) wire. Is this going to be strong enough, and will flux welds hold up compared to a weld with gas? Anyone in summit county colorado that wants to help out? Thanks!
Seasoned Member
Joined: Mar 2010
Posts: 379
Likes: 1
From: Modesto
Year: 1993
Model: Cherokee
Engine: 4.0 high output straight 6
the hobart handler will do the job just fine thats a good welder. Flux is just as strong as gas. gas and flux are just shielding agents the only issue with flux is that it splatters and pops alot more.
Just make sure to set your heat and feed to the right settings and get GOOD penetration.
Just make sure to set your heat and feed to the right settings and get GOOD penetration.
CF Veteran
Joined: Aug 2008
Posts: 6,588
Likes: 495
From: Chico, CA
Year: 1986
Model: Cherokee
Engine: 4.3L with headers and full 3" exhaust system
Plenty strong. Remember you are welding to thick sheet metal on the frame anyway. The metal in the wire is stronger than the mild steel you are welding to.
CF Veteran
Joined: Jun 2011
Posts: 2,858
Likes: 1
From: Nor-Cal
Year: 1990
Model: Cherokee
Engine: The venerable 4.0
You talkin axle or frame? I welded mine back on he axle with a Lincoln 120v and reinforced it with 3/16 steel. Worked beautifully. Just make sure you have deep even penetration (get your mind outta the gutter)
Thread
Thread Starter
Forum
Replies
Last Post
96Co
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
12
Jan 10, 2024 06:17 AM
Psiegrist1
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
34
Mar 17, 2022 02:15 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)