Finishing Lift advice
04-10-2014, 09:27 AM
#1
Member
Thread Starter
Join Date: Nov 2012
Location: British Columbia
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1993
Model: Cherokee
Engine: 4.0L
Finishing Lift advice
Couple questions! Been a while since I turned a wrench on my project but I just got my front axle rebuilt and re-geared so its time to start up again
Now that the front axle is temporarily set in place I could put the front springs in and measure how much lift I got front and rear!
Looks like 6.250" rear lift and 5.75" front lift! Front is without any isolator installed as factory ones were pooched! Parts are used so sag shouldn't occure!
How much factory rake did these come with? Wondering how big of an isolator to install without ruining the look?
Thx
Now that the front axle is temporarily set in place I could put the front springs in and measure how much lift I got front and rear!
Looks like 6.250" rear lift and 5.75" front lift! Front is without any isolator installed as factory ones were pooched! Parts are used so sag shouldn't occure!
How much factory rake did these come with? Wondering how big of an isolator to install without ruining the look?
Thx
Thread
Thread Starter
Forum
Replies
Last Post
jurazov
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
12
07-20-2023 04:13 AM
gwthamm
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
09-04-2015 11:29 AM
joshjeepnoob
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
09-04-2015 07:20 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)