coil rubbing bumpstop
#1
Old School CF Moderator
Thread Starter
Join Date: May 2010
Location: Chattanooga
Posts: 9,652
Likes: 0
Received 3 Likes
on
3 Posts
Year: 2001
Model: Cherokee
Engine: 4.0
coil rubbing bumpstop
My 4.5 inch coil is rubbing the edge of my driver side bunpstop. Its not horrible but when I get in I can hear the coil rubbing it. Any ideas? These are stock bunpstops
#4
Junior Member
What God said, or the bump stop tower is bent. How long has it been doing that? Have you come down hard on it recently?
#5
Old School CF Moderator
Thread Starter
Join Date: May 2010
Location: Chattanooga
Posts: 9,652
Likes: 0
Received 3 Likes
on
3 Posts
Year: 2001
Model: Cherokee
Engine: 4.0
I have yet to wheel it since going from 3 to 4.5 so it hadn't bern abused. It has fixed lcas for 4.5 inches and an adj trac bar. I guess I could go get an alignment to see if that helps
Trending Topics
#15
Former Sponsor
Join Date: Feb 2010
Location: Hesperia
Posts: 2,021
Likes: 0
Received 1 Like
on
1 Post
Year: 89
Model: Cherokee
Engine: 4.0
this^^
if your control arms are adjustable then they should be adjusted out a bit longer.
are you sure your caster is set right? if your axle is tilted too much it will make your coil bend.
if your control arms are adjustable then they should be adjusted out a bit longer.
are you sure your caster is set right? if your axle is tilted too much it will make your coil bend.