How do you make Bushwhackers, or the Napier V2, fit with a snorkel? I know I've seen an image before of it. I have the Safari which goes about 1" below that lip on the fender, and the Bushwhackers screw in right underneath that same lip.

 

I dont have the Safari snorkel but mine looks like it might be to close? but im not sure, I was just going to go with the flat fenders.

 

...you cut the fenders to fit...

 

You trim the flare to fit..

 

I don't want to trim the flare to fit. I want someone to produce a magical way to just make it work as is out of the box.

 

Well that's pretty much what you are going to have to do. Unless you have the Bushwacker flat fenders. If you have the pocket style flares, trimming is required.

 

then sell the snorkel. most add a snorkel but dont do the needed work of water proofing everything under the hood. they think it looks cool and forget about all the electronics.........

 

Or do what mean cherokee said but if you dont want to get rid of either plan on trimming a little bit of that flare.

 

.... electronics? .... ..

 

ur crazy y would u cut up a high dollar flare...

 

fuses, ecu, distributor all need to be waterproofed or the snorkel is worthless

 

OP it should fit just fine bc ur flares is below ur body line and the snorkel is above the body line... i have the BW flat flares and iv been looking in to getting a snorkel to

 

actuallythe 2 sets I have seen with a snorkel all had to trim some

 

No ****, why spend $500 on bushwackers just to cut them?

 

Actually the snorkel drops about 1/2-1" below the bodyline so when running Bushwaker Pocketstyle flares you have to notch out some of the flare to make it fit upagainst the snorkel.