Bumper problems
Thread Starter
Newbie
Joined: Mar 2017
Posts: 1
Likes: 0
Model: Cherokee
Bumper problems
Hi all,
I just got a 2000 Jeep Cherokee. I have some mods I need to do to it as well as some rust repair. I was wondering what the best way to get the front and back bumper trim pieces of was. I looked at them a little but it was kind of confusing.
P.S. I got a chance to try out the four wheel drive in a mud bog and it worked exponentially good. So stoked to mod this bad boy.
I just got a 2000 Jeep Cherokee. I have some mods I need to do to it as well as some rust repair. I was wondering what the best way to get the front and back bumper trim pieces of was. I looked at them a little but it was kind of confusing.
P.S. I got a chance to try out the four wheel drive in a mud bog and it worked exponentially good. So stoked to mod this bad boy.
CF Veteran
Joined: Apr 2014
Posts: 1,419
Likes: 1
From: Detroit, MI
Year: 1997
Model: Cherokee
Engine: I6 4.0L
It's really just a couple screws on the bottom of each (possibly some on the inside of the fronts). The rears (once you have the screws out) you need to kind of push out to clear the fender well, then slide them back off the brackets. It's been a bit since I've removed the fronts, but again, pretty sure it's just a couple screws.
You'll get this a lot on the forum, but "get under there and do some noggin poking". Look at it for a sec, see whats what. Remove a couple bolts and see what you end up with.
EDIT: Now that I think about it... there might be a rivet or two you'll need to drill out to get the fronts off.
You'll get this a lot on the forum, but "get under there and do some noggin poking". Look at it for a sec, see whats what. Remove a couple bolts and see what you end up with.
EDIT: Now that I think about it... there might be a rivet or two you'll need to drill out to get the fronts off.
Last edited by TFitzPat87; Mar 28, 2017 at 10:15 AM.
