Well.... Either way find a kit that comes with the dl.
Installing a sye on a 98 is cake. Took me less than an hour. Don't even have to pull the case.

 

Anyone ever used a transfer case drop on an aftermarket crossmember for longarms?

 

my drop is built in my iro crossmember. think i have an inch adj. between the bolt hol. so yes! lol

 

Quick question I have found a pretty good deal on a couple of used 275/75r15 tires. I am about to put on 33 12.5r15 on as my regulars. Can I use the 275/75r15 as my spare? I know it is a little smaller but I was hoping to get away with it. Thanks

 

as a spare it'll be ok - just keep it out of 4x4 when you have it on the truck

 

Don't do it! It's not strong enough

 

I believe Rusty's sells an after market crossmember with a 1" drop. But as OD said above, please dont put spacers unddr an after market x-member lol

 

I can use vaseline to put the injectors into the fuel rail right? Isn't it because it is petroleum based.

 

I used Vaseline yes

 

Cool thanks! I was reading your write up and couldn't tell if you said you used them to get the o rings on or to put them in the rail.

 

little 'o both. Just use a tiny bit

 

I have stock suspension on a 2000 xj whats the largest tires I can put on it without a lift kit

 

I have answered this question three times in this thread. So have a lot of other people. 235-75-15 with no fender trimming. If you wanna trim you could fit 31s with a bi of trimming if you do a total hack job maybe 33s

 

There needs to be a stickie that says just that haha

 

Yea for real.