Hello,

I'm sure this question has been asked in some form on this site before but I'm going to ask anyways...

For the passenger side installation of an amp, where is the best (easiest) location to go through the firewall? It seems that I could go on the drivers side pretty esily just about the main harness grommet, but I would really like to keep the install on the passenger side of the Jeep.

Also this is for a 97+

 

pull off pas.kick panel and there is a large wire loom. from the engine side just by the blower motor make a small hole in the gromet and run the wire though it. maybe tape some mec. wire because you can't get your hand in there from the inside if that makes sence.lol ill get a pic asap

 

Thanks for the pic...that helps a lot. I'll try and get that run tonight.