rideordie66

Thought this might be fun.
I'll get us started

I plan to wash and vacume the jeep for a wedding that I have to go to. Also, I plan to get the three strips of tape off that held the trim on the bottom of the doors and fenders and them maybe paint that area black.

rhino1

im going to look at it at some point and wish i were working on it.

ken72

I am finally going to get these 30" tires sitting in my garage put on. Then I am going to pull the rear bumper endcaps off and paint them black to match the bumper encaps that I painted a few months ago.

THENNING

hopefully start my roof rack build! if i ever get the time!

BLACKSPORT

hopefully get started on my steering linkage. Mines rubbing so its a good time to upgrade. all v8 zj stuff. Anyway if i dont start tomorrow then i will def start saturday.

mcguyver_xj

replace my trac-bar tie rod end as it is bad and maybe put some lucas in my power steering system

misfitcherokee01

just rained..new 33'' swampers? go through some damn mud!

rideordie66

All I got done today was clearing out the inside of all the build up from 6 long road trips. A bath is in order now and has to be done before I go to this wedding.

MjPioneer

I'll be getting sad over it's current state, and undercoating her.

GTPstarter

Taking her to Pocono Raceway. I'm working ,shes getting me there. Then with the money earned for the weekend , the 31x10.50's are going on Monday morning.

Vindicator9000

hopefully replacing front outer u-joints.

:scared:

alfreado121

tomorrow im ganna drive it to work and stare at it all day as it waits for me to get off
then im ganna give her an oil change and hopefully get my new 34 super swampers installed!!

Reefmike

Got my shocks wed., lift kit yesterday, and extended bumps today so tomorrow - it's lift time!! WOOHOO!!

Gee oh Dee

I'm gonna clean the roof off, sand a layer of clear off, tape off lines for racing stripes, and rattle can the rest of the truck black.

Then I'll finish cutting out the floors in front, hopefully weld in the new pans, and paint all my work inside.

builtnotbought89'

Try pass emissions again... Then if I pass I can pull off the ugly *** "fender flares" (fence slats screwed to my fenders) lol