Well i dunked it in a large creek (SE Jefferson County KY) at dawn trying to avoid rolling, oops. Water to headliner in rear fried camera currently drying out! Milky oil, dented and cracked exhaust on creek rock, bad vibration (thinking H2O in transmission?? getting a kind of bogging around 2000-3500 rpm, im thinking i need to drain my fluids and hope for the best! Any suggestions?, today's list is bondo for fender holes, paint, on and on and on, pure love for the machine!

 

Got it new toys.... 130 amp alt,new starter, new throttle body,big knuckle dana 44, and dana 60...all free!

 

I replaced my UCA Bushings.

First you take your control arm and remove the bolt:



then you put it up and out of the way:



then you take your All joint press and pop it out: (mind you on the drivers side I had to use a 1 5/16" socket on the end to push it all the way thru)



then once removed set your new one in:



and then press it all the way in:



and once it is seated bolt it all the way back up: (i drilled out the "bumps" and then used 1/2" hardware on mine)



Install time was just over an hour on the drivers side about 20 minutes on the passenger side

also found some new rock rash!

 

NICE! i regret selling my full width stuff

 

checked tire pressure. Im low on 3 tires! i just filled them up to 38 psi 2 weeks ago and now 3 are around 22. Great!

 

I trimmed the front frenders, fixed and painted some rust and then gave her a bath

 

Modified my RC track bar (at the axle mount) to allow for more flex!

 

by doing what?

 

Got a new project jeep

 

I increased the lower bend by approximately 20 degrees (originally it was at 10 degrees up, now it's 10 degrees down). Now I have no binding there when at full droop. I also installed a 1 ton TRE on the drag link at the pitman arm (which has an 18 degree bend) to alleviate the binding there as well. So much better!!

 

Changed the ignition coil tinkered around abit hung some of the wire in the engine bay that was loose. Bout to change this crank position sensor real quick before work. and it's not that. Then ill be right back in the morning... Yay Go JEEP...

 

Got er running thank god. Now shower and late to work... cant win em all

 

pulled an axle for my jeep

 

put on a new thrush welded muffler, she sounds beast now!

 

went offroading a little bit hows this look for flex?