I recently modified my cherokee doors to take them on and off and was wondering if anyone has a thread or a way to make some home made tube doors or at least the dimensions so i can fabricate my own

I think most folks use a tape measure.

https://www.google.com/search?q=Home...iw=928&bih=514

I built mine out of square tubing, just started with the piece for the door hinges welded some 1/4 inch bolts on the tubing then went from there.and used gate latches from the hardware store for latches

^this

Just so you know the fab section is for fabricated stuff not questions. Here is a sticky describing the fab section in case you wondering if your stuff is fab.

Moved to chat

If you have the skill necessary to fabricate them then you should have the knowledge on how to get the dimensions necessary.

I agree

i was just going to wing it and have a buddy weld it for me just thought it would be easier to see if someone had the dimensions from a previous build didn't think it would hurt to ask