Looking at the hnt sye and from what I read is it only works with lifts from 4.5-6.5 in by using front drive shaft off an xj. I'm looking at doing a 3" on my 2000 xj and I an considering doing the hnt to eliminate vibes. I would like to use the front drive shaft from an xj instead of going custom.

Who's done the hnt sye on a 3" lift and what driveshaft did you use?

 

SYE is nice and all, but not really required for a 3 inch lift.

 

Every XJ is different, maybe his does need it.

Iron Rock Offroad sells the hack n tap kit and a rebuild front shaft for about $200.

Or the just sell the yoke for $100 and you can pick up a JY shaft for around $50 probably

 

i know every cherokee is different. i have the c8.25 and have read about the longer pinion flange that causes drive line vibes. i seen the iro is selling the hnt kit for $100(the bit and die are extra) but it says for 4.5-6.5 lifts, but i dont know what drive shaft is being used for that application.

i have a pair of 1" tc drop brackets i made at work, maybe i should just them for now if needed and maybe go from there i guess.

 

I would go a head and do the sye just in case you want to lift higher later on your ready to go.