Just had all four floor pans replaced for my 95XJ Sport. Had her since new, and keeping her around for mo son who is just about to start driving soon. Got the floor pans from Quadratec, and the shop did a great job welding them in. Only problem is, the new pans don't come with new floor plugs. Any advice on where to either get some plugs, or good home solution for sealing?

Thanks!

 

I leave mine open.

You could use rubber grommets from the Help aisle at the parts store.

 

Thanks! Do you just use ruber mats on the floor then? Was just a little concerned about the rear passenger side since the mufler is so close to that one.

 

make a quick run to the junkyard and pop a few and pocket them just cut the carpet and on the driver side and in the cargo area bc there is two on the driver side and 4 in the cargo area along the back by the door and sides

 

Thanks!