rocker guards????
#6
Member
Join Date: Jan 2009
Location: Russellville, AR
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
Year: 90
Model: Cherokee
Engine: 4.0
http://www.naxja.org/forum/showthread.php?t=1005851
scroll down on that page and there is a diagram on that thread on how to build some and gives dimensions i built these. easy to build nice diagram
scroll down on that page and there is a diagram on that thread on how to build some and gives dimensions i built these. easy to build nice diagram
Trending Topics
#12
Do you hear banjos?
Yes, I have came down on them pretty hard, and had the entire weight of that side of the Jeep on them, and they didn't flinch. I wouldn't think twice about jacking against them at all.
Without a doubt...SUPER STRONG!!
They basically spread the load over the entire rocker panel, and are welded in placer. They aren't going anywhere!!
They basically spread the load over the entire rocker panel, and are welded in placer. They aren't going anywhere!!
#13
CF Veteran
Join Date: Jun 2009
Location: Denver, CO
Posts: 3,071
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0
COS those are awesome. I wish I woulda seen those before I got my sliders. Would've definitely gone that route. Rocker protection w/no loss of clearance!
... I may sell my sliders and do that later. Too bad my sliders are welded.
... I may sell my sliders and do that later. Too bad my sliders are welded.
#14
Junior Member
Join Date: Jul 2008
Location: Maine
Posts: 83
Likes: 0
Received 1 Like
on
1 Post
Year: 96
Model: Cherokee
Engine: 4.0 IL6
Extremely helpful thread.
Did you have a lot of rust behind the angle iron? Mine are badly rusted. The angle iron would help me pass inspection, but I wonder if the rust should all be cut out and then see what the situation looks like back there...
Did you have a lot of rust behind the angle iron? Mine are badly rusted. The angle iron would help me pass inspection, but I wonder if the rust should all be cut out and then see what the situation looks like back there...
#15
Member
Join Date: Jan 2009
Location: Russellville, AR
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
Year: 90
Model: Cherokee
Engine: 4.0
on mine i couldnt give you a est cost of materials i have a buddy the owns a welding shop and it was layin around so it was free.