Originally Posted by jhampton
(Post 1833148)
Slobber can. Fix's the oil soaked air filter cheap! All it takes is a an old oil quart bottle or I used a 20 ounce pop bottle, and a about 6-8 inches of rubber hose and A few clamps. I dremaled out a hole big enough for the hose in the lid and poked a few breather holes so the crank case can vent. Then close off the back with what ever method you deam useable. Sorry no pics and whenever it needs dumped out simply unscrew the cap and pull the bottle ad pour it out. No more oil soaked filter!
|
Originally Posted by CrawlerYJ
How much oil does it catch? |
Originally Posted by Barrelmaker
Grenade shifter
Needed : Grenade... Ar-15 shell 5/8 drill bit 3/8 drill bit My grenade already had a hole in the bottom so I opened it up with the 5/8 bit, this should slide into the shifter stick now. The grenade has a "Handel/top" I unscrewed this from the body then used the 3/8 bit to drill from the bottom all the way through this creates a hole for the shell Next the little white piece in the Handel should have a node on the top, this is what I shoved the shell onto. Put it together and that's it. A set screw would be recommended to hold it to the Handel secure |
How to... PLEASE!
If you don't post a how to thread we will all hate you!:001_tongue:
Originally Posted by macgyver35
(Post 1802646)
My self-built sealed sub enclosure with a 6.5" Kicker CompVT sub. I wanted something that didn't stick out into the rear cargo area at all, and looked as close to "factory" as I could get. Couldn't find anything so I built it myself.
https://www.cherokeeforum.com/member...all-133158.jpg |
1 Attachment(s)
Favorite mod :)
|
Originally Posted by FISHIES848
Favorite mod :)
How'd you do the hinge pin? |
Originally Posted by Barrelmaker
I really need to do this. How'd you do the hinge pin? |
Originally Posted by FISHIES848
If u have the beefier hinge, u cut the bottom ear off and the door slides off. On the passenger side, u have to drive out the pin and flip it to point down. Then undo the 9 wiring harnesses under the doors. Just go on google for some clearer writeups. Dremel with lots of little cutter wheels worked best for cutting hinge. |
Originally Posted by jhampton
Or a grinder with a cut off wheel. There is a thread in the how to section |
1 Attachment(s)
Originally Posted by FISHIES848
Ya today I finished the rears. Unbolt the three bolts and cut the bottom ear off of all 4 |
Originally Posted by FISHIES848
All done! |
Originally Posted by my89xj
Where did you get that bumper from? |
1 Attachment(s)
Originally Posted by my89xj
Where did you get that bumper from? |
Originally Posted by FISHIES848
Built it myself. JcrOffroad.com has a few that look the same! Check them out! |
1 Attachment(s)
Meant to throw this up on the 4th but got a little too busy so happy late 4th with my new fabbed up flag pole
Attachment 128939 |
All times are GMT -5. The time now is 03:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands