Boxed step plate fab

Reply Subscribe

Thread Tools

Search this Thread

Apr 5, 2011 | 02:10 PM

1ABrian

Thread Starter

CF Veteran

Joined: May 2010

Posts: 1,013

Likes: 1

From: New Hampshire

Year: 1997

Model: Grand Cherokee

Engine: 4.0

Boxed step plate fab

Made some custom step plates for a friends Dakota. Used some 2x4 steel for some HD pieces. Still have to make the tubes and fab to the chassis. I didn't have a mig avail so I used my arc.

Needed something HD cause hes a big dude

Apr 5, 2011 | 02:16 PM

odgreen

CF Veteran

Joined: Nov 2010

Posts: 15,581

Likes: 8

From: some small town oregon

Year: 1989

Model: Cherokee

Engine: 4.0

them some good looking steps!

Apr 5, 2011 | 02:20 PM

1ABrian

Thread Starter

CF Veteran

Joined: May 2010

Posts: 1,013

Likes: 1

From: New Hampshire

Year: 1997

Model: Grand Cherokee

Engine: 4.0

thanks man, not alot involved but fabbed the end caps also to seal em up

Apr 10, 2011 | 05:59 AM

ChileRedBateman

Member

Joined: May 2010

Posts: 182

Likes: 0

From: Concord, NH

Year: 1998

Model: Cherokee

Engine: 4.0L

would it be possible to run the tubes off right at the angle? thus sealing the open nubs from the angle piece and give a TINY bit of strength have the mounting tubes tucked in to the small corner...