-1996 Jeep Cherokee Sport
-4.0 H.O/AW4/231
-AA SYE, wide chain

-Front Axle
-HP Dana 30
-4.56 Motive gears
-JCR UTK 1-ton steering
-Rancho steering stabilizer mount
-Rough Country quick discos
- Solid Diff. Cover

Rear Axle
-XJ D44
-4.56 Motive Gears
-Aussie Locker
-Solid Diff. Cover
-Disk brake Conversion (ZJ D35 parts and Rubicon D44 parts)

Suspension
-Rough Country Long Arm kit
-6.5" RC coils
-4.5" RC leafs
-1.5" RC shackles
-RC braided brake lines
-RC 2.2 performance shocks
-HD Engineering Shackle Relocation Brackets (V2)

Tires/Wheels
-33x10.5x15 BFG KM2's
-Procomp black D window wheels

Armor
-Home brew custom front bumper
-C4x4 rear bumper
-JCR stage 3 sliders
-Rough Country tcase skid
-oil pan skid
-OverlandXJ rear corner guards
-Gas tank skid

Misc
-Custom rear driveshaft
-Smittybuilt XRC8 winch
-Cobra CB radio
-Motion Offroad CB antenna mount
-River Raider Hi-Lift mounts
-Hella 500's
-Safari Snorkle
-Rustys steering box brace
-M.O.R.E motor mounts
-Durango steering box
-Pontiac GTX hood vents
-Optima Red Top
-v8 ZJ front sway bar
-Kenwood cd player
-Mossy Oak headliner
-99+ Door seals
-99+ Side Mirrors
-ZJ leather seats
-Rear side storage lock box
-Iron Man Trac Bar





Future Mods: Yes, huge list

Build Thread:

https://www.cherokeeforum.com/f46/pr...rthwoods-3541/

 

2000 Jeep Cherokee Sport
stock 4.0 194k miles
stock aw4
np231 with Advance Adapters short SYE kit

High pinion D30/Chrysler 29 spline 8.25
Nitro 4.88's
Aussie lockers front and rear
Zj V8 solid tie rod
Tattons custom rear driveshaft
Rebuilt front with new spicer joints
Rubicon express 4.5" front coils
RE adjustable track bar and drop bracket with cross brace
Rustys drop pitman arm
Ballistic lower control arm mounts
Rustys 6.5" rear springs, with 2 springs removed
JKS 1" boomerang shackles.
Rustys shocks
Custom built x-member
1.750 .250 wall long arms, ruff stuff heims.
Pro comp d window 15x8 wheels
35x12.50x15 BFG KM2'S
on board air.
Custom built tube front bumper with 8000lb winch

Its not a crazy setup but it works unreal.

Future plans are.
Nitro chromoly front shafts with 300m joints
or 60's front and rear with 37's.
Im still going back and forth.
1.5" dom heim steering
and to give it plenty more "trail character"

 

DaddyGreenGenes-->Richmond VA

1998 Cherokee Limited. 4.0L, AW4, NP242, D30+C8.25

Wheels/Tires:
-32x11.5x15 Procomp MT's on 15x8 MT II's. 2 full size spares
-Bushwacker Flares+fender trimming

Suspension:
-4.5" RC x-series w/ LCA drop brackets and full leaf packs
-Johnny Joints
-RC heavy duty tie-rod w/ ZJ TRE's
-All Polyurethane mounts (Daystar Master bushing kit)
-Polyurethane Engine and Transmission Mounts
-28mm swaybar
-RC swaybar quick disconnects
-Stainless Steel brake lines
-Airlift Airbags + Firestone pressure gauge/pneumatic switch

Drivetrain:
-Tom Woods SYE and DriveShaft
-All Royal Purple Fluids

Steering:
-Durango steering box, AGR Superpump, JCR inner steering box brace

Engine/Intake/Exhaust Mods:
-Rebuilt Engine
-703 Injectors
-'99 Intake Manifold
-Bored TB
-Spectre 4" Inline Airbox
-Accel Tune-Up Kit
-Magnaflow Cat+Catback system
-Borla Header (ceramic coated)
-Downpipe also ceramic coated)
-Mean Green Alternator
-Dual Optima Yellow Tops w/ Painless Power Manager

Cooling System Mods:
-CSF 3row radiator
-Severe Duty fan clutch w/ stock fan
-Flowkooler Water Pump
-High flow themostat housing and 180 degree themostat
-Runcool Hood Louver Kit
-B&M 20,000 BTU trans cooler
-Trans cooler in radiator is now a power steering cooler

Front Axle: HP Dana 30
-4.56 Gears
-ARB air locker
-ARB diff cover
-Lubelocker gasket
-ZJ ball joints, new knuckles and hubs
-Billet axle tube seals
-Upgraded U-joints
-SSBC brake upgrade

Rear Axle: C8.25 Corporate
-4.56 Gears
-ARB air locker
-Blue Torch diff cover
-Lubelocker gasket
-Tom Woods Gold Seal U-joints
-New Drum Brakes
-New bearings and seals

Armor/Recovery:
-Custom 4x4 Fab Front Winch Bumper w/ Brushguard
-Custom 4x4 Fab Rear Bumper w/ tire carrier
-Promark Silverback 8k winch
-Stock engine, trans, and gas tank skids
-Class 3/4 Hitch

Interior:
-Leather, All power
-JVC touchscreen CD/DVD/MP3 head unit
-Cobra 75 WXST CB w/ 4ft Firestik
-Vent Pod switch panels
-Trailer Brake controller and 7-way plug
-Bedlined 20mm ammo can
-Viair Constant Duty OBA
-HHO fuel cell (currently installing)
-Gauge Pod on A-Pillar
-Trans temp gauge
-Airbag gauge+switch
-OBA pressure gauge in trans tunnel
-Extended Idle

Exterior
-1100w of offroad lighting (All Rugged Ridge)
6" round x7
5"x7" square x4
-roof rack (recently blasted and repainted)
-Airflow Snorkel

Misc:
-Paint (white to green)
-all new A/C compressor, drier/accumulator
-All new transmission/cooling/power steering hoses

Future Plans:
-Detours unibody reinforcing sliders
-recessed rear winch

 

I guess I'll have to compete to get my picture up there this time.

1993 Jeep Cherokee Country 4.0, AW4, NP231
Suspension:

Rusty’s ~5” Coil spring
Rusty’s ~6” Leaf spring
2nd Gen Rock Krawler 3-link

Axles:
Wagoneer Dana 44-

Moser Chromoly out shafts
Yukon Chromoly inner shafts
CTM U-joints
Full carrier Detroit locker
Ruff Stuff Diff cover
Custom Truss
Custom brackets
Custom 1.5x.25 DOM Steering and trac-bar
Hydraulic Assist
5x5.5 Conversion
Warn Premium hubs

Ford 8.8:

Disc brakes
Chromoly shafts
Full carrier Detroit Locker
Tires:
(5) 35x12.50r15 BFG KM1s
15x8 Cragar D-Windows

Interior:

Corbeau Baja SS Suspension seats
8-point roll cage
Racequip 5 point harnesses
Fancy little CB radio

Body:

Chopped Top
I have no clue where the doors are
Dents

Armor/Recovery:

Smittybilt XRC8
Custom built bumper f/r with recovery points on all 4 corners.
2x6 Rocker replacements/sliders
LCA Skids
Plated unibody front/rear

Pics:
Playing on a hay bale in the front yard and on a trail behind my house. Got out for a poser picture.

 

This is out baby (Ours would be myself and my 16 year old daughter) We both have put our love in to her so far. I get the daughter out there working on things with me when ever I can get her out there and she is the one that is my copilot on every trip out. Soon to come is a XJ for her that we will be building up.
Here is what has been done so far:
89 XJ 4.0
5" SkyJacker lift
Trimmed out front and rear
Garden edging wheel flairs
Bradded extended SkyJacker brake lines
33X12.50X15
D30 8.25 29spl rear
Spartan locker in front axle
Cheap light bare with cheap lights
OBA with 6 gallon tank
Custom front bumper designed to completely in case a winch (coming in a month)
After market 3/16" gas skid
Things to come soon and on the wish list:
Rocker replacements
Rear bumper with swing out tire carrier
Roof rack
Rear cargo area rack
Long arm set up
8000 lbs winch
Half doors
4.56 gears
4.7 stroker
Maybe 35" tires

Our 16 year old daughter learning how to mount tires.

 

Hey Everyone, apologize about this taking longer then usual. I've never setup COTM, but I'm gonna give it my best shot. I think it'd only be fair to run COTM voting until Sunday, February 5th. Thus, the same amount of time is equated. February COTM will open as normal on February 1st.


Good Luck everyone!

 

 

Good luck to everyone!

 

voted...GO JAKE!!

 

tough vote this month. Nice rigs! Hey BustedkNuckle - you spelled it wrong, not Pole, Pull!

 

Voted. I wanna wheel in some snow!

I like how we're automatically subscribed.

 

Cherokee forum is different then other forums it seems. Here the cleanest rigs win. I love the built chopped xj look. Great looking rigs everybody.

 

Mee too!

 

jacob gets my vote

 

Look like this year's COTM's are gonna be just as tough as last year's.