So you have it back together? And its still leaking?


It's not ideal, but it should be ok

 

So you have it back together? And its still leaking?


It's not ideal, but it should be ok

 

ya we put it all back together and its leaking really bad. im not even driving it and its leaking alot

 

jb weld and let it cure for the full 24 hours. do you have the broken peice?

 

i did till it fell in the oil and my buddy dumped it!

 

so how do i go about it without the piece

 

that may be the problem.may need to go fishing

 

problem is im out of town and its at my buddys garage. hopefully they didnt clean!! if i cant get it should i even attempt to fix it

 

opps yes that ill be a problem.. just had to take another look and its not good place...

 

For the location trying to JB weld it and getting it to cure right will be a b#$%h. Think your f#$%ed nows a good time to learn how to do an engine swap i guess. I had a block crack on me where the motor bolts up to the trans. I JB welded it after i cleaned it real good but then again that was a better place to work on it. Suppose if you have the piece that chipped off you might have better luck but i think you are pretty much sol on a fix for that. Try it, hope for the best but expect the worst and in the meantime start looking for another engine, thats what i would do.

 

Found a 97 4.0 but my jeeps a 95. Guy wants 150$ and its got 120k on it. He removed it because he got rear ended. I don't know if it will work since its an obd2 engine.

 

may be swap a few sensor

 

Like what? He's only got the engine

 

it will work

 

I heard the only thing that may not work is the temp gauge.