I'm new to Jeeps and just picked up a 94' Jeep grand cherokee laredo with 86,000 miles. I'm planning on using this for my winter vehicle. My question is the passenger side fender is smashed in and I found a fender off of a 97' Jeep grand cherokee laredo. Will this fit and be a direct bolt on?

 

93 thru 98 will fit.

 

nice! thanks for the fast reply! how hard is it to remove? Figure bolts inside engine bay, two behind rear wheel and one on inner fender?

 

I replaced my left front fender, it was kind of a pain in the balloon knot! There are the screws at the top by the hood, there are a few behind the marker light, there are a few towards the front that go in from the bottom, and there is one by the door. Take your time and look before yanking on something. There are two brackets at the rear of the fender that look like they're screwed on, but you can't get in there to remove them. They are just stuck on and will come off the fender with a little careful prying, just be very careful on where you pry. There are two 10mm at the bottom rear of the fender too, you have to remove the lower plastic trim to get to them. remove the splash shield to gain access to all of the inner bolts, it just clips in, but there are rivits that secure it to the front bumper cover.