Blower Motor Wire Harness
#1
Newbie
Thread Starter
Join Date: Jul 2013
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
Blower Motor Wire Harness
I have 97 jeep grand cherokee, my a/c will work when I first start the car then it cuts out after a few minutes. Read some other forum and they suggested the resistor, well took it down and unplugged the wire harness, turns out it has melted. I am trying to find just the replacement plug but am having no luck..Does anyone have any suggestions on where to find one of these or how to rig it up? It's a 3 wire plug with 3 metal pins. Thanks for your help!
#3
Remove the resistor module from under the passengers side dash....remove cover. You will see the charred wires. Cut, clean and reattach. Hardwire it to the module!!! You will need to solder to the pins.
Been there done that.
Been there done that.
Thread
Thread Starter
Forum
Replies
Last Post
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
Dannymac1216
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
09-08-2015 06:28 AM
Jicki Rough
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
09-02-2015 09:36 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)