All zj mod's go here
 

Been reading threads on here for about two years now and i see all kinds of mods for XJ's. My first jeep was a XJ but now i have me a ZJ and looking for some cool mods to look at and maybe use with my rig.
SO POST PICS AND DESCRIPTIONS OF ALLL THE MODS!

Bedlined my plastics with Rust-o-Leum bedliner spray.

Looks good how many cans did u use ?
And was it hard to get the plastic cladding
Off and on ?

Attachment 391969

Attachment 391970

herculiner from the body line down on my old ZJ

Rolled my fenders 1 1/2" and beat the hell out of my pinch seam to fit 33's on a 3.5" lift with no rub

Attachment 391971

Attachment 391972

XJ flares on a ZJ. Not spending $500 for something that is going to get ripped off on the trail. Total cost $60. Used 2 front flares and 5 rear flares. Cut everything to follow the ZJ lines as close as possible on the rear. Cut and joined to follow lines on the front. Used a heat gun to shape to ZJ lines.
Still have to sand epoxy and paint

Attachment 391973

Attachment 391974

Attachment 391975

Will be building custom front winch bumper and custom rear bumper w/a storage compartment. Will post pics when done

Mike

Looks good man what size u running on that jeep ? 33's? That front bumpers is looking pretty damn beefy too u buy it or build it?

I really like the fender how u cut it . Did u just cut verticle line throughout or did u just do one horizontal cut ? I may try that on mine.

In the picture it had 33's (but they were junk, I ran 31" super swampers) It has like a 2" budget boost done to it. And no i didn't make the bumper, I build a Yamaha Blaster and traded it for the Jeep

We build the bumper on my current Jeep

Attachment 391976

Its a lot better than the other, it give me better clearance on trails, plus this jeep is lifted 4.5 inches

I cut vertical lines 1 1/2" up, and in between pinch welds. Bend up into wheel well. Used Deadblow to shape, and welded a few of the tabs for more strength.
Mike

nice,somewhere to put zj mods

Mo ved to tech since this is not a fabrication thread. Fabrication is something like building a bumper from scratch. Modifying your rig is not fabricating.

Sorry just educating as I move. :) Enjoy!

Nice, I'll post up anything I do here to keep it going!

some 2x6 rockers i made a while ago, does this count as a mod or as a fab? oh well

http://i1032.photobucket.com/albums/...5809135138.jpg

http://i1032.photobucket.com/albums/...5809123990.jpg

For the 2x6 rockers did you remove your rocker panels or put the rockers under them?